STEMx module for qDPC plug-in for Gatan DigitalMicrograph
--------------------------------------------------------------------------------

Version 1.3.3
May 2026

--------------------------------------------------------------------------------
Contact

General enquiries on the SmartAlign for DigitalMicrograph should be sent to: 
HREM Research Inc.
14-48 Matsukazedai
Higashimatsuyama 
Saitama 355-0055
Japan

email: support@hremresearch.com
Website: http://www.hremresearch.com /

--------------------------------------------------------------------------------
Files
	- qDPC64_STEMx.gtk: main compiled script file
	- qDPC64_STEMx.dll: dll file
	- qDPC64_STEMx2.dll: dll file
	- ReadMe.txt: this file

[NOTE] IPU plug-in should be also installed to run this plug-in.

--------------------------------------------------------------------------------
Installation
	Installation is straightforward. Just copy the files to following folder.
	Go to \Gatan\DigitalMicrograph\Plugins folder: qDPC64_STEMx.gtk, qDPC64_STEMx.dll, qDPC64_STEMx2.dll

--------------------------------------------------------------------------------
Release Notes
1.3.3   Bug fix
1.3.2   DPC signals can be calculated from STEMx data saved in the dm5 format (GMS 3.5)
1.3.1   DPC signals can be calculated from STEMx data saved on a mass storage (GMS 3.4 or later)
1.3     Addition of quasi-realtime (this requires an additional license)
1.1     Support new format
1.0     The first release for STEMx module